DIY Roach Clip Wand – No More Burnt Fingers

Supply List Includes:

• Thin Gauge Wire
• Alligator Clip
• Beads (Glass, Stone, Wood, Plastic, whatever you like as long as the hole is small enough to fit on your wire)
• Jewelry Glue
• Needle Nose Pliers & Wire Cutters

Directions:

STEP ONE- Cut Wire to Length 

Firstly, cut your metal wire to the length you would like your roach clip wand to be.

STEP TWO- Glue Alligator Clip to Wire

Glue your metal wire to the bottom side of your alligator clip and let it dry.

STEP THREE- Secure Alligator Clip

Use your needle nose pliers to push down the tabs on the alligator clip to keep the metal wire in place.

STEP FOUR- Add Beads

Add your beads onto your wire. This can be whatever you want. So you can be as creative as you want.

STEP FIVE- Glue Last Bead

Put a small amount of glue in the bottom hole of your last bead, then slip it onto the wire also place some glue in the top hole.

STEP SIX- Chill and Let Glue Dry

You’re done! Just clip your roach wand to something so it is standing up-right and let the glue dry.

Burn One Down: Roll up some of your medical marijuana into a joint and smoke it! Once your joint has become a roach, pinch it into your roach clip wand. And voila!